Frage von topgun:
Hello,
I'm new here and ziemlikch but have already tried the search without finding anything.
I remember in one Forrum Instructions to have seen the Beyerdynamich cam 72 with its holder better s.Blitzschuh camera mounted. Simply put, without locking thumbscrew with my opinion, is dangerous.
Has anyone any idea where these "instructions" for a better attachment to find?
Thanks for an answer!
Antwort von Johannes:
Whom you know when you were in this forum so you can have
the Hysotrie (Chronicle, ..) menu on this page back
return.
John:)
Antwort von topgun:
Thanks for the reply,
've Been about 3 weeks in the forum and almost every day. Your proposal does not help me much.
Nevertheless, thank you
TopGun
Antwort von Johannes:
You hate it seen in this forum?
John
Antwort von rtzbild:
Hello, what do you like s.der bracket not?
If it going to be shaky, take a strip _längs_ Gaffa tape around the foot drum, then stuck it better.
If Andean vertical drill, threaded through an AND Allen screw fixing.
HTH
Olli
Antwort von topgun:
HI,
OK, the thing with the tape I try, should actually funzen.
With the drill senkrekt I do not know what you mean, because s.Fuss sits below a thread. The problem is how do I set the stable attachment with the hot shoe forth, normally a knurled used
PS: I'm no longer sure whether I Baunleitung in this special Slashcamform have seen ...
Antwort von topgun:
HI,
OK, the thing with the tape I try, should actually funzen.
With the drill senkrekt I do not know what you mean, because s.Fuss sits below a thread. The problem is how do I set the stable attachment with the hot shoe forth, normally a knurled used
PS: I'm no longer sure whether I Baunleitung in this special Slashcamform have seen ...
Antwort von rtzbild:
Hi Topgun,
Take time out to contribute again, double post, o)
Can you please Pic times of the foot-line, so I can see what is going on?
Why do you not use the thumbscrew?
If the foot is already a thread (verm M4 / M5), but simply make a short (nylon)-screw up of pure and good?
Olli
Antwort von nightworker:
Hello,
Thank you for the answers. I have the solution and now found themselves in:
The Micro was a M10 bolt with 2 knurled nut at. I did not know what it was until I had noticed that the thread s.der suspension may turn out (from the M6 will be a thread M10) and then with the screw plate for the camcorder shoe eindrehen can. With the two thumbscrews can be both upward as synonymous down the whole place.
In any case, thanks for the effort,
Gruss
Topgun
