Frage von Mike305:Hello videographers,
are the forum here I've discovered I look very happy times again you will always find something useful. Now to my question, I own a Panasonic NV-GS500 and I have an external Micro to fetch, Hama RMZ 14 stereo when I use the micro to run the camera and directly connect it works but once I use the cable to lengthen it s.einer other agency to operate, there's just a buzz. In what could be the subject or it can extend a micro?
Gruß Mike ...
Antwort von Eugen von ...:
In what could be the subject or it can extend a micro? Quite certainly a wrong configuration or faulty extension cable (how long?). From 5 m on the already good for nothing, because it already s.kürzeren lengths as an antenna capture all sorts of interference. Only the very good + expensive cables are well shielded.
Since I would prefer to use a radio link: much more flexible, much more range and not idiots who are on the cable rumlatschen.
Antwort von AndyZZ:
Since you will probably the 50 Hz mains hum capture.
Antwort von steveb:
At best, we used a micro which is a cable can be expected. Thus, when a defective cable is not equal to the whole micro waste.
Antwort von Mike305:
The cable is about 10 meters long, it is theoretically possible, the cable subsequently abzuschirmen or as a well-shielded must be set up (name).
Thanks for the tips so far.
Gruß Mike ...
Antwort von Markus:
The cable is about 10 meters long ... That is much too long for an unbalanced microphone cable. If you are interested in the basics (which they should be ;-) then look into this discussion:
Karitative Einrichtung zur Verköstigung verarmter Schlossgeister...Auch das hier könnte interessant sein:
Balanced Microphone input to the (almost) free ... it is theoretically possible, the cable subsequently abzuschirmen ...? Yes, in theory is possible. In this case this is not feasible, because often synonymous Microphone and camcorder need to be shielded. But build take a Faraday cage with 10 m length. ;-)
Look at times prefer to begin the second thread linked to.
Antwort von Mike305:
That with the symmetric and asymmetric micro pipes is very interesting, but in my case it does not really help next, I have a 10 meter long cable caused a buzz, which is a well-shielded cable, what criteria is there?
Gruß Mike ...
Antwort von Markus:
... I have a 10 meter long cable caused a buzz, which is a well-shielded cable, what criteria is there? Does the microphone cable, perhaps close to a (variable-) electrical cable? Crosses it is perhaps a cable, in which high current strengths are?
Thinking synonymous s.Stromleitung who lost in the wall and thus are not obvious.
Antwort von DWUA:
A 50 Hz buzz would be an existing alarm
by its noise
only store. The questioner, however, speaks of
ONLY! a buzz.
So it is s.Verlängerungskabel and its
Male / female, as
Eugen of .. above suspicion.
Antwort von peha:
Hi,
as a well-shielded must be set up (name) Each wire should be shielded. Look under 'microphone cable' at Conrad or musician needs stores like Thomann.
Wirds richtig gut but probably only with XLR connection. Very interesting thread about this (especially the contributions of Gesierich):
http://forum.slashcam.de/anfangerfrage-prof-xlr-mikro-an-cinch-camcorder-vt59381.html?highlight=gesierich
Gruss
Peter
Antwort von Markus:
The questioner, however, speaks of ONLY! a buzz.
So it is s.Verlängerungskabel and the Male / Female, as Eugen of .. above suspicion. Is that I had read about.