Frage von roko03:
Hello,
I have a SonyDig8-CAM with intelligent Zubehoerschur; the DigCAM has a zoom slider (no rockers). The zoom slider causes Koerperschall, which is taken up by the microphone.
The sensitivity is mitigated somewhat, in which the foam is Zubehoerschuh with ausgepolstet, but well, it is not yet available.
Who has suggestions?
Antwort von Axel Segebrecht:
Hi Roko03,
I'm going assume that your views on the hotshoe mic sits and has no decoupling. Then I would create a Mic Shockmount with conditions like eg Rode SM3, assuming you have a Roehrenmic.
If you I would not suggest a Rode VideoMic. This has great quality, is suitable to any hotshoe and fully decoupled.
Good luck,
Axel.
Antwort von Markus:
Hello,
wenns fit, would perhaps synonymous, the elastic suspensions of Beyerdynamic interesting.
Learn more about this (with links) to the Manufacturer:
... Beyerdynamic spider EA 19/25 ...
Antwort von roko03:
Hello,
Thanks for the advice.
But I have a SonyDigCAM with intelligent Zubehoerschuh and a suitable microphone in favor. That is, the power and signal connection is via the 8 contacts of Zubehoerschuhs, so no cable connection.
I Db (need if I want to buy me a new one) mute a solution the existing connection ziwschen Mic and Camera, or to decouple.
Gruss
roko
Antwort von Markus:
... mute a solution, the existing connection ziwschen Mic and Camera, or to decouple. Sorry, something I do not know. Moreover, I doubt that there is such a thing.
Maybe someone knows better?
Antwort von Dj Dino:
Hm
Sounds audacious, but I remember only this: You can try to gently connect zwsichen microphone housing and the shoe base and to separate between a rubber (eg a thick rubber gasket from the plumbing department) affix (gummitauglicher glue 2-component adhesive resin-based zb) approximately as scheme is meant ...:
-----------------------------------
M ä ikrofongeh use
-----------------------------------
| Socket Neck |
| Rubber Part |
| Socket Neck |
| Accessory shoe |
-----------------------------------
C amcorder
-----------------------------------
Perhaps the signal is transferred here ntürlich not damaged cables may be difficult to halt werden.Dürfte only once reingesägt too much and have a cable can then sein.Neben rubber spider mounting rubber cushions are used for decoupling synonymous, although they are less effective but certainly better than nothing.
Probably better you do the software side, reduce the interference signal through either (mostly so in the equalizer Motorized = 200Hz area to be reduced to what needs to be there) but then, unfortunately, synonymous the whole sound picture is distorted and somewhat unnatural läst.
Virtually any video editing software should have an equalizer for that.
Better, therefore, the exact method of frequency analysis of the interference signal and subsequent wave cancellation (analog signals mutual
Antwort von Dj Dino:
(
