Frage von mokelmann05:
Hello,
I American equipment (NTSC) in a television studio here in Germany, which is later evlt. synonymous via satellite to send? There are Converter which can convert the signal. Do the cameras will be synonymous NTSC? I would be grateful if someone could explain maö, beginning of recording until the uplink, where exactly determine PAL or NTSC, etc.
I thank you very much for the help,
mokelmann
Antwort von robbie:
There are several possibilities as an answer to your question. It depends of course, all of various factors.
But simply put s.diesem point s.dem you use NTSC, NTSC you need to stay.
It is the easiest as far back as possible to work with NTSC, or s.Besten not to work.
In studios and on satellite at the jungle will normally only AFTER the playout converted to NTSC, or often not at all synonymous, depending on the recipient of the content.
In the major American broadcasters, you will think I have no problem if you want the material in PAL rüberspielst, which then convert the reception. That is, simply put a 19Zoll part, front and rear inside PAL NTSC out, and purely in the MAZ. Done. Conversely, of course, synonymous.
Schöne Grüße,
Robbie
Antwort von Quadruplex:
I American equipment (NTSC) in a television studio here in Germany use Defined "use". If you're in the studio picture and sound infrastructure einklinken want, it's probably difficult, as long as someone you do not explicitly agrees, with NTSC equipment to be able to work. Often enough stuck s.den's quite simple things, ie sockets and voltage.
Basics: Look at your target format / land. If you are mainly or exclusively for NTSC-producing countries, to work fully with NTSC. If you put your main customers in PAL-/Secam-Ländern did, are you working with PAL.
The fewer conversions PAL / NTSC video through your needs, the better it looks. Even the best standard converter operating principle can not operate without loss.
Antwort von Markus:
... can I American equipment (NTSC) in a television studio here in Germany use the ... When it comes to a couple of NTSC equipment in a PAL-studio environment to integrate, it will be problematic. The PAL devices want as a studio beat 50 Hz, NTSC 60 Hz Device To that must be reconciled, should s.jedem completion point of PAL NTSC after a VT sit. - That would be costly and quality.
