Frage von kornhaas@nexgo.de:
I have a question or a problem.
I own a SonyVX2100 and the microphones MCE72 CAM and CAM MCE86 that in tests with very well have been evaluated.
Do I control the sound from manual and I think that the High-Level at-6db, I have a very audible noise. If I disqualify later, the sound tends to distort on loud passages. In the automatic mode is not detectable on control, but in quiet passages of a very audible noise.
"Adjust" the Sennheiser microphones not SonyVX2100 or what am I doing wrong
Antwort von Maze:
Could it be that you somewhere in the menu level reduction've set? something called a "pad" or "mic att." This is the microphone you have to be higher auspegeln (because even a basic cut is enabled) and the noise increased. basically can not really audible rustle mikro if it is good ausgepegelt the incoming signal and a basic volume has.
Antwort von kornhaas@nexgo.de:
Hi Mace,
thank you for the answer.
In the menu of the VX2100, there is no point to such a reduction.
Could it be that the impedance of the output circuit of the Microphone and the input circuit of the VX2100 so different, that there are problems?
Gruss
roko03
Antwort von rush:
Hi,
how close are you doing with your microphone s.der record source? as the camera microphone on the camera? so you will certainly not optimal recordings (especially o-ton) without "noise" can be achieved.
Antwort von K.-D. Schmidt:
It is not s.den microphones, but s.Camcorders.
The Sony device mentioned roars with manual audio control significantly greater than in the automatic mode.
Greeting
KDS
Antwort von SebiG:
Hello,
thank you for the answers.
Bzgl. Location and distance from the Camera:
I'm trying as close as possible to its source s.der and mount the microphone in a meter on a Mikrofonstaender.
Bzgl. Sony device known regarding Noise:
How "high" should be in the VX2100 manual disqualify?
If I use the internal microphone, the recording quality is poor, but the noise is significantly lower.
Why is this and what can you do?
Gruss
Roko03
