Frage von Sess:
Hello,
can someone tell me how I can realize:
I have a scene in a different effect with the "cube" is blinded.
Now I would like zusäzlich that I die "as a whole" can see.
That is, if a picture turns away, the cube will rausgezoomt and then as a whole can be seen, and if the other Picture reinschiebt again reingezoomt will.
Practically, the cube to "back into the Picture" and then be pushed back rangeholt, while the scene changes.
I already have with Skallierung, camera view, the anchor point. herumvesucht etc., without success.
Ps: Please, no "hints" that other software is easier, that is obvious to me.
Lieben Gruß,
Sess
Antwort von Toccamonium:
It is not just that the other software can be easier, but with the premiere you can not do. The cube-Effect unfortunately produced no complete cube, but only the part that you see in Effect. And since no synonymous Premiere 3D levels, you will not synonymous otherwise tinker cubes can.
Antwort von Sess:
Well, if I am only the two sides of the cube look on which the building is not the 3-D, I think.
Top, bottom, etc. of the cube, I do not need.
If yes only to the 2 walls, the rear are piecewise diene.
