Frage von Asra:
Hello,
I have the following problem:
I work with After Effects CS4 with Trapcode Particular and set out a motion blur. When I try to render anything happens, it will only create a mov. That has 0 KB, and nothing else moves. If I then Renden of continuation AE crashes.
anyone has any idea what might that be?
I would be really grateful for answers!
Antwort von Jake the rake:
anyone has any idea what might that be? Too many, too big, too?? Particles.
A bit more info would be helpful to the scene.
Antwort von Asra:
I reduced the scene have already switched to the "bad :-)" particles to figure out what it now stands is therefore now a comp with 800 X 600 pixels to a light that serves as an emitter, and this single-particle level
I do not believe that it is too big when I get out of the blurring take gehts synonymous. I now have a little experiment next round and if I just (; Approx. 10) then give out individual frames hauts synonymous out when I want to render the entire 10 seconds is nothing. I can verify on the basis of the created file, whether that is getting bigger after some time, but unfortunately there doing nothing, it always remains at 0 KB and AE is no longer accessible. I work with Mac s.einem Octa Gigaherz 2.66.
Antwort von Jake the rake:
Have you already purchased the upgrade to 2.0? This fact may raise your 8 Kerndln, otherwise they not help you ....
One question is whether you in your scene with a particle that does any good ...
Otherwise, test times with "CC force motion blur" ...
Antwort von Asra:
Hi,
the version with which I work is the 9.0.2.42 dva: 2.0.0.16 ...
whether the most recent one I do not know, but would be great if you could tell me whether the OctaMac already supported or not, I find very interesting ...
the motion blur I've turned on the Mode bar, so is (no effect, might have been smart if I had said this about this ...)
Thanks schonmal!
Antwort von B.DeKid:
Let's give but without motion blur from the leg and later about it (;?)
Antwort von TiMovie:
I had exactly the same problem - ie if you Bewegungsuns. in the "box" is checked is garnix!
I solved that problem that you are in trapc. particular jump can activate motion blur!
Antwort von Asra:
@ B. DeKid: it's not supposed to be everywhere the motion blur is only through the particles are and which are unfortunately rather nested in the animation. I could give out all in different levels ... but is rather laborious and not synonymous, I think the result is the same.
@ TiMovie: thanks for the tip, I'll try, but you have found for the general problem synonymous no solution? is not so elegant ...:(;
Antwort von Asra:
So, habs jetzt mal with the Motion Blur tried in trapcode Particular and looks great! :) Thank you so again! synonymous if I still think it's stupid, it's no other way!
Antwort von Jake the rake:
I had exactly the same problem - ie if you Bewegungsuns. in the "box" is checked is garnix!
I solved that problem that you are in trapc. particular jump can activate motion blur! The default is "use comp settings" for "Motion blur" set.
@ Azra: But you need to know which version you have you bought?
How long ago was that, and you have an update done since then? (; Update on 2 is charged to provide so goes the rather more difficult;))
Antwort von Asra:
Hi,
ne unfortunately I do not know which version, because I have not bought synonymous but my boss ...;) I work as a graphic designer and currently expanding my field of animation.
the boss, of course, synonymous, I have already asked, but has not in view, because he does not work with it.
