Frage von xxtrash:
Hi,
I want to be a professional green screen cavetto together. On the ideal would be an L-shaped cavetto like http://www.havelstudios.de/images/fotos/Atelier1/Hohlkehle/hohlkehle_03.jpg here in green or deleted: http://www.havelstudios.de/images/fotos/Atelier1/Hohlkehle/hohlkehle_02.jpg.
Not scare: all so great and high, the proposed Green Screen will not ... ;-)
Have you any idea what kind of material you used for (a schlabbriger substance which is not seeming to be)?
Or perhaps you're a (book-) Recommendation regarding the indication of materials and Lighting is concerned? 've Obviously synonymous search used, but unfortunately only small craft instructions for living-Bluescreen found ;-)
Inter Nette greetings & thanks for your tips
Lars
Antwort von Bernd E.:
Maybe you get a couple of suggestions here next:
www.finalcutprofi.de/phpboard/viewtopic.php?p=20608&sid=b330e4a2e7b2cbcff212db32a8d541ff
Gruß Bernd E.
Antwort von LarsP:
Thanks for the link.
The trick there with the moistened gypsum boards on a frame of "quarter-circle segments monitert seems to be quite good. In order to get at least schonmal a clean / complete conclusion to the ground. I, however, if synonymous pretty "wabbelig" already synonymous with a Blue Screen of cardboard unrolled photo right.
The problem with this, it will be above Gipstechnik only if in addition to cavetto synonymous at the bottom corner of the studio, the "round" is (just like at the start linked pictures) ...
Antwort von Falk:
Hi,
I always have my fillets with hard board made, this is the stuff back in the IKEA cabinets used. I think this country is called Press paperboard.
The boards are approximately 1.20 m x 2,40 m.
The best way to build only one plant stand on the thin chipboard are screwed. With an L-shaped cavetto both rear and Seitenwnd ground.
Then draw on the back a horizontal line at 1m Height and then temporarily bolted a wooden bar across the entire length.
Now take one of the plates, she of the short bottom with Page against the bar and push them across the floor towards the wall to get the correct radius is reached.
Now with festtackern nails. Then the next it, etc.
On the side then the same again.
The transitions between the plates with a special cover and Klabeband Ruffling up.
In the remaining free corner between rear, side and bottom layers of Styrofoam plates and glue. The protruding material with a hot wire or a flexible knife (Filiermesser) to cut and sand nuances.
Then synonymous here the transitions to the plates Ruffling up again, a thin layer Moltofill it and grind again.
Finally deleted.
If someday cracks appear, simply highlight drüber.
Gruß, Falk
