Infoseite // Re: My microphone mounting anti-vibration mounts & Mod



Frage von DjDino (Toth Dominik):


Link

Space


Antwort von beiti:

Interesting modification. I like that s.end the microphone is still quite compact (unlike the spiders, or placing the cages in which we must) use a complete microphone. But I have three questions:

To 3:
How effective is the structure-borne noise decoupling? Have you made comparison shots?
If the wind really thin enough synonymous during the shooting on a windy hill or the like?

To 6:
Why does the microphone must be able to rotate to the sides?

Space


Antwort von DjDino (Toth Dominik):

"beiti" wrote:

To 3:
How effective is the structure-borne noise decoupling? Have you made comparison shots?
If the wind really thin enough synonymous during the shooting on a windy hill or the like?

To 6:
Why does the microphone must be able to rotate to the sides?


Rotate towards the sides was perhaps a little stupid words, I am talking more about it so I can just turn around 180 degrees (to the right so that it starts with the micro-cable) so it shows to me and I may objector comments (Do not ask me why not a Manufacturer has come up with this idea)

The decoupling is exceptionally good, but I am not surprised because it's actually a Doppelaufängung in the rubber spider, that is precisely the 2 mic capsules hang in a rubber cross which in turn (again) hanging in a 2nd Cross which then gum s.Gitterkäfig rim is mounted. In fact, virtually all "Stopel mics" the old Hi8/VHSC-Camcorders are made - why this technology today and one will hardly prin Entkopplungstrümer instead, this must be put on the shoe erstmal is a mystery to me. A test showed the way of me almost no structure-borne sound is transmitted more because if I plugged the microphone in the same position or not makes no difference in drive noise, or in other words, the only remaining causes of penetrating drive noise is close to the microphone to the drive . The microphone position s.Picture drive noises can be perceived as only very slightly when I play with the video editing> video, the PC speaker, I have a burn aufdreh.Schiebe the Microphone in the terminals even next to the front (about 5cm longer So maximum), the drive noise in the micro-or no self-noise preamplifier still hören.Comparison to the built-in camcorder-Microphone certainly a dream.

The Winschutz is only ~ 5mm thick and therefore only very slight "Mailüftchen" reasonably effective, now I have him ersetzt.Am best by a (slightly thicker ~ 1cm) would obviously be a skin but I could unfortunately not yet for microphones with 2cm Diameter locate.

Space


Antwort von DjDino (Toth Dominik):

Addendum:

Comparison - drive noise audio files:

MVX40-Internal Microphone:
mvx_40_original_micro.mp3

MVX40-Eigenbau Microphone :
mvx40_eigenbau_micro.mp3

The difference is hard to ignore!

Space


Antwort von beiti:

That sounds at first both cruel. How did you get the test done? Specifically, according Driven hochgepegelt or later?

But clearly, the self-built micro sounds much better. Do you notice the sounds synonymous to the touch, for example, with the fingers if you play around s.Camcorders housing? This is the occasion on which I produce s.meisten unwanted noise.

Space


Antwort von DjDino (Toth Dominik):

"beiti" wrote: That sounds at first both cruel. How did you get the test done? Specifically, according Driven hochgepegelt or later?
I should have known better dazusagen: The test recordings with (via camcorder), automatic level control, which was intended to by the high tax is the difference in quiet passages clearly machen.Zudem was the level when you convert to mp3 normalized to 100% so that the Level of the 2 audio files ansich synonymous ensure identical and the correct Listen Comparison with abwächselndem gewährleistet.Ich think it is a fair Comparison s.besten.Bei manual fixed level, it is with the Noise & Co, of course, not so bad and can self-built micro dominieren.Das even more self-built micro rushes unfortunately a bit more since I have the older capsule condenser microphone (built-in mesh cage) (well, technically are just s.Stand of ~ 1990) - but can be quite good with Noise filters wegbekommen.Die test shots but otherwise raw, processed, therefore not qualiativ.
"beiti" wrote: Do you notice the sounds synonymous to the touch, for example, with the fingers if you play around s.Camcorders housing?
This is already eher.Das is (I suspect) because the no-vibration mounts of the whole microphone housing is available but only for a decoupling capacitor microphone capsules in the microphone housing - is now mounted as close to these capsules s.Mikrofongehäuse (because it) and it firmly with the camcorder is connected to housing they can scrape things like s.Gehäuse, fiddle, and so easy to absorb, listen to or less "(because it remembers the synonymous to a decoupling of the microphone housing has a meaning, as eg in

Space





slashCAM nutzt Cookies zur Optimierung des Angebots, auch Cookies Dritter. Die Speicherung von Cookies kann in den Browsereinstellungen unterbunden werden. Mehr Informationen erhalten Sie in unserer Datenschutzerklärung. Mehr Infos Verstanden!
RSS Suche YouTube Facebook Twitter slashCAM-Slash