Frage von maus1208:
Hello
I intend soon a Canon HV-20 to buy, but what bothers me is they do not have a LANC port Zoomfernbedienung has. Schade.
I assume that the Zoomfahrten not exactly clean, ie fine start and stop fine. Question therefore:
Gibt's ne way this "shortcoming" software to fix, maybe Final Cut Pro or other, for example where you can adjust speed Directions?
I hope there is ne solution.
Thank you for tips.
Gruss Saamjo
Antwort von PowerMac:
SmoothCam in Final Cut Pro can do quite well. Also jerky start-up or get the ending zoom out. With HD material is particularly good, but the render times pleasingly short.
Antwort von maus1208:
Thanks for the tip, Powermac, but the analysis times are not quite happig, see comments http://www.slashcam.de/news/single/Final-Cut--Studio-2-SmoothCam-Tutorial-6363.html
Antwort von PowerMac:
I think they're okay. Elsewhere, it takes much longer. The analysis of the movement takes a little time, but with reduced Subclips or clips is pretty fast.
Antwort von Axel:
I think they're okay. Elsewhere, it takes much longer. The analysis of the movement takes a little time, but with reduced Subclips or clips is pretty fast. ... However, with the clip until reduced export and import should be back, otherwise it will always be the entire Masterclip analyzed. However, it is a reference movie to export (ie the check box "as an independent film secure" should not be selected)> thus will not repeat the clip on the hard drive is written. Sounds complicated, is in reality a matter of three or four clicks and a few seconds, and it shortens the analysis time usually orders of magnitude.
Antwort von krummhorn:
Saamjo Hello!
The lack of Lanc jack canon HV 20 was my first
KO criterion. Picture, Auto Focus, stabilization uvssind however Comparison to other HD cameras this price segment, so overwhelming that I look at the camera for ¬ 790th - (!!!!) had purchased.
..... even though I almost exclusively by Tripod (auchBrustst.) and rear -
Remote camera movies ......... I have the following solution for the
Problem is chosen:
On the surface of the infrared receiver (front s.der HV 20) as synonymous to
the donor of the infrared remote control with a hot glue one
Toslink coupler geklebt.Ein 50 cm long Toslink cable connects the
two Toslink connectors ....... finished behind the camera operation.
The functions of the Billigstfernbedienung are limited, but the
Major works reliably (on / off, zoom, Still image during the
Filming and display on / off).
At your initial question: Can HV 20 with sensible zoom perform?
Yes! In the Camera menu, you can select four-speed.
Various (dhje upon wieDu the zoom lever bedienst-wenig/langsam, heftig / schnell..funktioniert does not in practice), and the
Speeds of 1, 2 .3.
If you choose the preset 1, get a price for this segment really good Kriechzoom (ca, 35 -40 sec), which is synonymous relatively soft starts and ends as synonymous.
And with a cheap remote control via a fiber optic cable.
Before the HV 20 for you to exclude, guck 'they prefer you again
s.un just look at the blog of HDV proboscis (www.fxsupport.de)
ca.S.21.
Schöne Grüße jürgen
