Frage von quincy998:
Hi, who can help?
I have before me the above brief Camera after I bought at the trial's most of them as best for me rausgefiltert had (was not quite synonymous cheap). to the TOP synonymous HD recordings to be able to process I would go the newest Pinnacle Studio 12Ultimate increased. By then I had to scare note that only the studio with Fire Wire einlesbar is. Now you should think that a TOP unit of Sony Fire Wire has-far from it. According to the Sony support: is the way you sell, but Sony editing software. Since my studio is now in the garbage can not cut now will I need a tip. According to Pinnacle is synonymous USB transfer (determined ass slow). Thank you Sony!
My Studio software does not recognize the camera when connected to USB and depends on, (activated) is. What can I do that my HD camcorder movies of the studio can handle, thank you for your help. Please explain idiot sure I'm not a professional (you have certainly already noticed synonymous) Thanks Sven
Antwort von minnie:
Hello, what version of Studio 12 did you?
Can really only a problem of your PC, if you Studio 12 plus or ultimate searched. Does it actually recognize!
Antwort von Bruno Peter:
Please explain idiot sure I'm not a professional (you have certainly already noticed synonymous) Hopefully you can read little more than ...
Simply copy with the Windows File Explorer, the clips on PC hard drive.
As you have the camera with the PC to connect, you are in the manual ...
However Pinnacle Studio can do much more elegant, if you read the manual times would. Studio patch, you should of course also be installed.
Antwort von RickyMartini:
Hallösche and welcome in the non-streaming era! :)
You need the camcorder via USB s.den Calculator? and then located in the directory STREAM MTS files to disk copy.
It hurts, but not equal to the entire AVCHD directory to the plate to slide.
The camcorder's memory card and be recognized as Lauwerke and the added work. A detailed study of the manual that came with the new acquisitions is also very advisable (RTFM)! : D
The editing program then reads these MTS files of the disk of the computer if the appropriate directory for the Dateimport opens.
Antwort von heimax:
Good evening
Fire Wire is HDD camcorders in principle no longer s.Bord too cumbersome and only in real time a transfer is possible. USB is faster at worlds.
A brief instructions.
1. Install the attached program of Camera Picture Motion Browser.
2. Close the camera via USB to s.den Calculator.
3. Turn Camera On.
4. The display of the USB Camera Vervbindung activate.
5. Transfer Program s.Calculator opens independently.
6. Location in the PC set.
7. Transfer files.
Time required for one hour film: Approx. 7 minutes.
8. Importing files into the studio.
9. Film Editing.
If in doubt, the manual of the camera look at it, and read the correct section.
Gruss mags
Antwort von quincy998:
Thanks s.alle. now I myself durchgebissen. The manual I have already read, so thanks for the tip synonymous.
My life experience, which once again confirms that all of the opinions and listen to instructions, with the knowledge that statistically, never can have any right, then extract it form the Scrap forget the realistic tips and then take himself off to grow.
no preference - now it works good to know that there are people here like to help, Thanks again for this!
Antwort von Bruno Peter:
Thanks s.alle. now I myself durchgebissen. Now you're pro!
Antwort von mgeip:
Hello quincy998
I have the same problem, but still seemed to be stupid than you, because the answers have not helped me. After all, I have my film can bring to the Pinnacle, the clips Jerkiness there long before him, it takes an eternity, a clip in the timeline to place. What the hell have you helped with the problem?
