Frage von melone:
Hello,
We have a Canon HV20 and one C253 Manfrotto Tripod, Velbon now with video head, and a Canon EOS400D with telephoto zoom lens.
We are looking for
- Can handle a favorable real fluid video-Neiger, with the video - and still camera
- S.besten with damping
(- If possible, suitable for portrait photos)
From Manfrotto I found the following:
Manfrotto 128RC Micro
Manfrotto 128LP Micro
Manfrotto 700RC2 Mini
Manfrotto 701RC2 Midi
Manfrotto 701HDV Video Tilt
Does anybody know what this Neiger have a damping?
What would you recommend?
Thanks, melon.
Antwort von kalle70:
Take the 701HDV. Is there and there for $ 100.
The others are maybe 15 or 20 euros cheaper.
This pays, but not enough.
Antwort von bigaxl:
Among the 503 HDV, I would advise you not to start.
Antwort von Johannes:
Among the 503 HDV, I would advise you not to start. Standt The 503 HDV, but not his choice, especially since the camera for this is almost too easy.
I have seen the 701 HDV and briefly tested and found it very good. Except for the size it is almost equal with the 501HDV.
Antwort von kalle70:
Was recently in the shop and wanted to buy a new head for my Manfrotto tripod Triman.
The goal was the 501HDV. When I saw the part I was amazed at the size! The 501HDV is a huge part (;) the 503HDV fortiori.
My little TRV900E does not exactly filled out grotesquely.
Apart from that, this camera with nearly 1 n.zu easy for the 501HDV.
The specialist has advised me the 701HDV.
Something subtle, and well suited for smaller cameras.
This head is for about $ 100 a bargain.
However, it should be synonymous to a good tripod mounted.
Antwort von deti:
The 701HDV is used for the price really good, but the settings are relatively low and needs to be done in the fine motor aspects of the camera perhaps a few compromises. This applies especially to handle the full zoom: Here s.Griff during filming should not be any significant wobbling (not supported) for example, or reach out his hand away.
Deti
Antwort von Johannes:
... This mainly concerns the manipulation at full zoom: Here s.Griff during filming should not be any significant wobbling (not supported) for example, or reach out his hand away. Therefore we have indeed always synonymous with a rubber in my pocket, even with the 501HDV I would work in the telephoto range with no rubber no.
Antwort von melone:
Thanks for your answers and recommendations!
I have to ask my question a bit more special.
In my current video head, I have just the following problems:
(, 1) when I swing it and s.end the pivotal movement have arrived and want to stop, the video makes a tiny head backward, which is seen flat. Perhaps synonymous (an operator error;) beginners.
(, 2) If I (the screw; Tighten the left of the head) to determine the inclination or something tightening, the head tilts slightly to the left. That is (at the horizon shots, sea) very disturbing. When one compensates for this tendency difference then s.der tripod setting, you can forget pans, because then no longer true.
I have these problems with 701 HDV synonymous or is it normal?
At 501 HDV on amazon is synonymous report to the inclination of a problem.
Since I was upset that during a trip, now I'm looking for a head, where this does not occur.
Therefore we have indeed always synonymous with a rubber in my pocket, even with the 501HDV I would work in the telephoto range with no rubber no.
Can you explain more? What is meant with rubber?
Antwort von minidv:
When rubber transmits the trembling of your hand rather than the swivel arm and it can be realized easily Smooth movements.
Antwort von kalle70:
(, 1) when I swing it and s.end the pivotal movement have arrived and want to stop, the video makes a tiny head backward, which is seen flat.
Have you turned on the Image Stabilization?
(, 2) If I (the screw; Tighten the left of the head) to determine the inclination or something tightening, the head tilts slightly to the left. That is (at the horizon shots, sea) very disturbing. When one compensates for this tendency difference then s.der tripod setting, you can forget pans, because then no longer true.
Which head did you get?
Can you explain more? What is meant with rubber?
The rubber is pulled over the pan handle and then with his fingers hooked into the rubber and pulled behold, the head swivels with buttery soft start and end ..
Antwort von beiti:
(, 1) when I swing it and s.end the pivotal movement have arrived and want to stop, the video makes a tiny head backward, which is seen flat. Perhaps synonymous (an operator error;) beginners. That is not likely s.Kopf but s.den tripod legs: (In the wheel; vswenn head a strong attenuation) has turned to his legs slightly and put under stress (; not see with the naked eye), and when you release the pivoting lever to make them again. In contrast, a warp-resistant tripod helps you form the loss or s.Kopf a minor.
(, 2) If I (the screw; Tighten the left of the head) to determine the inclination or something tightening, the head tilts slightly to the left. That is (at the horizon shots, sea) very disturbing. The distortion in tightening is unfortunately a problem of almost all the light fluid video heads. Even the much-praised Velbon PH-368 (; DV -7000) is no exception. Tighten only one remedy: Not at all or as little as possible, ie so that the camera tilts just do not.
Antwort von melone:
(, 1) when I swing it and s.end the pivotal movement have arrived and want to stop, the video makes a tiny head backward, which is seen flat.
Have you turned on the Image Stabilization?
Yes, but it feels after a mechanical problem.
(, 2) If I (the screw; Tighten the left of the head) to determine the inclination or something tightening, the head tilts slightly to the left. That is (at the horizon shots, sea) very disturbing. When one compensates for this tendency difference then s.der tripod setting, you can forget pans, because then no longer true.
Which head did you get?
PH-368. Maybe I caught a Monday model. Which is otherwise so much praise ....
Can you explain more? What is meant with rubber?
The rubber is pulled over the pan handle and then with his fingers hooked into the rubber and pulled behold, the head swivels with buttery soft start and end ..
(, 1) when I swing it and s.end the pivotal movement have arrived and want to stop, the video makes a tiny head backward, which is seen flat. Perhaps synonymous (an operator error;) beginners. That is not likely s.Kopf but s.den tripod legs: (In the wheel; vswenn head a strong attenuation) has turned to his legs slightly and put under stress (; not see with the naked eye), and when you release the pivoting lever to make them again. In contrast, a warp-resistant tripod helps you form the loss or s.Kopf a minor.
Hmm, which of course can be. Did Although a carbon fiber tripod only without Mittelverstrebung. I must test times.
(, 2) If I (the screw; Tighten the left of the head) to determine the inclination or something tightening, the head tilts slightly to the left. That is (at the horizon shots, sea) very disturbing. The distortion in tightening is unfortunately a problem of almost all the light fluid video heads. Even the much-praised Velbon PH-368 (; DV -7000) is no exception. Tighten only one remedy: Not at all or as little as possible, ie so that the camera tilts just do not.
Is there a head in the ¬ 100 range, which when this is not so?
@ kalle70 you have the 701 HDV. Is it synonymous with the?
 |
Antwort von kalle70:
Basically, the Image Stabilization is (; optical or electronical) off when using a tripod.
Described the effect of tilting the head so far I could not even say, s.keinem my tripods.
However, the clamp screw with me always, as far as possible open.
Antwort von melone:
So, thanks for your tips!
Then you would really recommend the 701 HDV?
Is synonymous not too big for my camera?
Is there someone who has this video head?
I would like to know whether anyone in this Tilt-occurring problem or @ kalle70 times you could test whether the tightening of the screw for adjusting the inclination of the camera or video head to the left or right inclined?
