Frage von blazenizer:
Hello,
I have to run without errors before an external LaCie 230 GB of hard drive in Macintosh Formatur s.einem Windows Calculator via Firewire & MacDrive. A program has forced me to reboot and I forgot to eject the disk. Thus, when switching off a hundred times without problems happen, but now I'm in the moment of reboot became aware of a noise that was supposedly a new one, like a pop. Occurred to me before but not so bad, so just forget it, until then the computer back up and the plate under the drives in "My Computer" was no longer present. The icon in the taskbar to the "safe removal" is still present there, the device characteristics is "ready", but the rider Volumes finds "the computer while the hard information rather than the standard volume, ie there is no drive letter assigned, etc.
When I connect the disk s.einen Mac, as everything is always visible and available, the hard disks synonymous utility reports no errors.
At the Firewire port from the PC it is, I believe, is not synonymous, as a DV camera is well, it still is recognized, etc. So the software? Or is it hardware? My two Firewire ports (both have the same problem) s.einer cheap ebay junk-PCI card. Windows XP, AMD Athlon 2800 + or something.
Who knows what?
Much obliged!
Antwort von Markus:
The icon in the taskbar to the "safe removal" is still present there, the device characteristics is "ready" ... In this case, remove the external device's talk about "safe removal", it separates from the PC and close it after a short waiting period. Such things often helps to have, possibly synonymous with cold-start all units involved.
Good luck!
Antwort von blazenizer:
Thanks, but already been done, no change. Have many times under different conditions (plate, it's plate, times in, times out, this port, since port) are restarted, all identified and restarted, still the same error.
I sent the text above synonymous s.Lacie whose prompt (commendable) to answer went like this:
"The PC no longer recognizes the file system because it a one OS
Datisystem is to be mounted and the other only via a software plug-in
can.
You should reinstall the plugin and then try the disk
mount.
Use it and share the formatting of the disk utility and
that it to FAT32. "
With software plug-in I have assumed that mean the MacDrive, which I then synonymous reinstalled without success. About the disk utility to format, I would not count on FAT32, because it probably delete all data?
Otherwise, the state of my knowledge is now so far:
Computer Management has in the Windows disk status Not Initialized ", which probably really just plain new, the case. I can turn this thing then online, but Windows will then make its own Something in the MDR (or something similar had, more accurate forgotten) that I will order the part synonymous gets a drive letter that is to create a partition. I'm not sure because I do so, as before, using the standard volume. At least that is still not detected as before.
And if nothing comes, I'll just burn s.Mac DVD for DVD with the data fully, so I can reformat that FP ... out, however, I have no desire to do?
Antwort von blazenizer:
To those few, which will accommodate the same problem again: The program was causing "Alcohol 120%" which sets Drivers installed STPD called, sticks of synonymous in other burning programs. I had then immediately uninstalled the program again, but nothing has been good because the drivers were left on my computer, and remained active.
On this Page you can now download a program that can uninstall and reinstall the selfsame Drivers (SPTDinst) x86/x64:
http://www2.daemon-tools.cc/dtcc/download.php?mode=ViewCategory&catid=5
Then when I ran everything as s.ersten day. 've Already told the Alcohol and cucumber, so that's probably not repeated.
All, goes back, I'm glad ...
