Frage von serserstmal:
I've bought a zoom H4N recorder. As an external mic I use the NTG-2 with phantom power. This has, until recently, still works quite well.
Just now I got to get really intense noise.
H4N -> 48V phantom power on -> cable is not connected: OK!
H4N -> 48V phantom power on -> cable connected: Fault!
H4N -> phantom power off -> cable connected: OK!
H4N -> 48V phantom power on -> cable connected: Fault!
H4N -
Battery inserted -> phantom power from> - cable connected>: OK!
What do you think might be what it?
I type on cable's can not test this, unfortunately, because I have no other XLR available. : (;
Greetings
Antwort von tommyb:
Screw the male or female to and look, whether there is a short s.den cables. Trying to connect it times without plastic covering on it ...
Antwort von serserstmal:
How do I know the short circuit? In the low voltage is likely to happen because nothing right? Had not noticed ..
Antwort von thos-berlin:
As far as I know, the Phantom voltage is between the shield and the signal conductors. If there is a short circuit (or touching) between the Abschrimung and an audio conductor, then it should be synonymous cause interference.
Do you have friends and acquaintances in an electrician or electrical hobbyists that can traverse the cable again?
The visual search of the short circuit in the plugs is simple: Look the wiring in Male and clutch s.and see if there are bare parts irgenwelche touch (especially single fibers of the individual manager).
Ansosnsten: binding'll buy the 15 ¬ to the leg and the big C or the big T is a new cable.
Antwort von tommyb:
If parts should touch on the times, it's very helpful to isolate it with tape (no tape or lasso-like, too thick!) Of each other.
Antwort von Pianist:
How do I know the short circuit? In the low voltage is likely to happen because nothing right? Had not noticed .. It's enough if a single copper hair has slightly loosened and easily touched another pole, then just come about this audible interference. So look very closely, something may well happen again.
Matthias
Antwort von serserstmal:
Get down the cable (two weeks) to return again and a new me. But you are synonymous sure it is s.Kabel right? If that is not unusual to see the cable.
In another thread I was wondering what cable is recommended. Add the link just in here, then you can determine where next.
Thank you for your help!
-> http://forum.slashcam.de/richtmikrofon-handgerausche-unterdrucken-vp452782.html#452782
Antwort von serserstmal:
Now I need to do it again report .. And although I still noticed something strange. A noise (see appendix), which is not always there.
To the notes: I s.Anfang from the Phantospeisung, then I turn on her, then back off, then on again. Then I take the cable s.and mount it again.
The noise is only there when the phantom power s.ist and the cable is connected. (Everything s.h4n)
