Frage von Blackeagle123:
Hello,
I want my (stereo) audio signal from DVD player s.das mixer s.den and TV output. For this I use a Y-RCA Male.
The same, I want to do with the video. Does it, if so, a difference in the picture visible?
If not, what it suggests?
Many greetings,
Constantin
Antwort von tommyb:
As long as there is only a simple cable, you'll get a drop in the brightness observed.
However, if your TV has a built in amplifier, then it will balance out. Not optimal, but still.
Alternatively, you should see an active (ie with power and a little electronics inside) Video Splitter take.
Antwort von Blackeagle123:
Thank you very much!
Can you find such a cheap (!) Active splitter recommend? Interestingly, it would then probably be a video on 3 will be split. Because someday you will probably have little more brightness ;-)
Many greetings,
Constantin
Antwort von megalutzi:
Hi Constantin,
For example,
these The Ebay has a few video distributors (this search term) in the offer. Are there some differences, but all better than a Y-Male. Warning: The search returns a few synonymous switch. The bringing in your case, of course, nothing.
Antwort von Blackeagle123:
Top! Times is not expensive ...
1) Should I use a splitter such as synonymous use to split audio?
2) I was once recommended that speakers do not s.die same fuse as the monitors to hang synonymous when it was still tube devices were. Should I as synonymous with a splitter to watch out for?
If I were an XLR signal splitter, do I have an active splitter synonymous use?
Many greetings,
Constantin
Antwort von megalutzi:
Hello,
I failed to separate video and audio.
Reason: The performance of my audio equipment is minimal. However, I have not tuned PA, but only recording equipment.
I once kicked out a backup. Since I had still 4 CRT monitors (while switched on). This time I now no longer (I've also synonymous None 4 tubes longer in use).
Audio must I usually barely split. If, then once through a distribution (the program with ingetegriertem audio signal). This may be the quiet, but nothing for high-ways. So nothing for sound. The distributors are not symmetrical. XLR split only on symmetric distribution. But there are separate factions (both active and passive). Are not necessarily synonymous expensive. But what quality and price, because I better be silent, as some know better ...
I have a passive XLR splitter (a Durchschliff and 2 isolated outputs). The whole stereo: s.meines knowledge no cost ¬ 50. For my purposes reichts, synonymous when I know that something really cheap may not be good (at least if I go after what Tonprofis of themselves)
Antwort von Blackeagle123:
Hey,
I just hold together again, as I then want to do:
I buy only 3 factions to the video s.den PC / TV s.den mixer and to give. 2x Audio and 1xVideo.
I have considered that I do not need XLR shard, since I got out of the mixer in the form of RCA can go out. Then I go on s.meinen RCA audio analyzer and s.den PC (D / A converter) for recording. Here I use a fourth synonymous RCA splitter. Maybe I can synonymous of a special monitor output from the signal output, that always has the same volume. Do I have again carefully about.
(Previously it was planned the XLR signal that s.die boxes is to split and s.den audio analyzer adapter.)
Many greetings,
Constantin
Antwort von megalutzi:
Hello,
uh, I do not really understand what and how you want to do it.
At best, it is always a picture, or schema waveform drawing. Go on a 2D-CAD program, you can but synonymous well by hand or with any other drawing program to make. So I always visualize complex projects and therefore synonymous established.
Poste, the Picture, then I understand it is synonymous ... ;-)
